x
uploads/recloser.jpg

recloser n.【電學】自動開關,自動接入繼電器;反復充電設備。

reclothe

This thesis presents a single - terminal fault location technique that is used together with recloser . the technique takes advantage of reclosing of single - terminal recloser to eliminate the influence of the remote source impedance . a distributed parameter line model is used for the proposed algorithm , thus the technique can be used in hv transmission line 為了克服這一缺點,本文提出了與自動重合閘配合使用的單端故障測距方法,根據電力系統的運行特點,利用故障線路在試送電時自動重合閘的單端重合狀態來消除對端系統的影響,測距算法建立在分布參數模型基礎上,使其可應用于高壓輸電線路。

Operation of the manual open handle also disables any local or remote closing operation until the handle is reset . once reset , the recloser can be closed using the control 手動分開關操作的同時也閉鎖了就地或者遠方控制命令,直到手柄復位才使重合器解除閉鎖狀態。

Roper control selection , applied with the viper recloser , provides great flexibility for automated sectionalizing schemes and other control algorithms 應用viper重合器,選擇恰當的控制器,可以極大的提高自動控制分段方案和其他控制邏輯的靈活性。

Numerous preprogrammed and user - defined time current curves for sensing phase or ground faults . - three independent recloser interval times 對于相間和接地故障,有很多條預定義的或者用戶可定義的時間電流曲線可供選擇。

The magnetic actuator and interface electronics are located in a separate compartment at the bottom of the recloser for easy access , if required 電磁動作機構和操作界面位于重合器底部一個單獨的隔間里,便于操作。

A dead - line operation option permits using the batteries located in the control for operation of the recloser if ac input power is lost 失壓線路方案在不能提供操作電源的情況下,控制器的內置的電池進行操作。

Threaded style connectors make cable connection between control and recloser extremely easy 電纜式連接控制線使控制器和重合器之間的連接非常方便。

Specification for 12kv h . v . alternating current automatic circuit recloser 12kv高壓交流自動重合器技術條件

Once reset , the recloser can be closed using the control 根據方案需要,也可以與其他控制器配合。

The contact status is also displayed at the recloser control 觸頭位置狀態在控制器上也有顯示。

Specification for combined recloser equipment 綜合重合閘裝置技術條件

Pulling the handle down trips and locks out the recloser 拉下手柄將跳開斷路器并閉鎖開關。